Thermodynamic analysis of recompression Brayton power cycle for nuclear power plants

Authors

Andrey Rogalev1 ID,  Daniil Patorkin1 ID,  Viacheslav Murashov1*  ID,  Vladimir Korolev1 ID,  Alexey Malenkov1 ID
Show Less
1 National Research University “Moscow Power Engineering Institute”, 111250 Russia, Moscow
Article ID: 1073
0 Views

DOI:

https://doi.org/10.18686/cest1073

Keywords:

nuclear power plant; HTR-10; Brayton cycle; supercritical carbon dioxide; thermodynamic optimization

Abstract

Widespread commercial deployment of innovative nuclear power plant designs is frequently constrained by the high specific capital cost of installed capacity. A promising solution involves transitioning from traditional steam-water loops to supercritical carbon dioxide (s-CO2) Brayton cycles. According to the literature, this approach enables a substantial reduction in the size and mass of turbomachinery and heat exchangers, thereby reducing overall capital expenditures. This study aims to select and thermodynamically optimize an s-CO2 cycle configuration to ensure maximum energy efficiency when integrated with the 10 MW High Temperature Gas-cooled Reactor (HTR-10) high-temperature gas-cooled reactor. Thermodynamic modeling was performed in Python using the CoolProp library. The Nelder-Mead simplex method was applied to determine optimal operating parameters—low pressure and recompression fraction—across turbine inlet pressures ranging from 12 to 35 MPa. Three CO2 cycle schemes were evaluated: simple, recuperative, and recompression. Results showed the simple Brayton cycle yields the lowest thermal efficiency (23.6%). Adding recuperation increases efficiency to 42.9%. The recompression scheme achieves the highest energy efficiency, reaching a maximum thermal efficiency of 50.6% at an initial pressure of 30 MPa, a cooler pressure of 7.8 MPa, and a recompression fraction of 0.67. A parametric zone of maximum efficiency was identified between 28 and 31 MPa. Ultimately, subject to the adopted assumptions, transitioning to a recompression s-CO2 cycle allows the thermal efficiency to be nearly doubled compared to the baseline HTR-10 plant design. Optimizing parameters near the critical CO2 region minimizes compression costs and enhances recuperation.

References

1. General Plan for the Location of Electric Power Facilities until 2042. Supporting Materials. Available online: https://www.so-ups.ru/fileadmin/files/company/future_plan/genshema/public_discussion/2024/genschema_justification_2024.pdf (accessed on 10 August 2026). (in Russian)

2. Projected Costs of Generating Electricity – 2020 Edition. Available online: https://www.oecd-nea.org/jcms/pl_51110/projected-costs-of-generating-electricity-2020-edition?details=true (accessed on 10 August 2026).

3. Rogalev N, Rogalev A, Kindra V, et al. Review of Closed SCO₂ and Semi-Closed Oxy–Fuel Combustion Power Cycles for Multi-Scale Power Generation in Terms of Energy, Ecology and Economic Efficiency. Energies. 2022; 15(23): 9226. doi: 10.3390/en15239226

4. Kindra VO, Maksimov IA, Komarov II, et al. Small Power Nuclear Plants: Technical Level and Prospects for Commercialization (Review). Thermal Engineering. 2024; 71(4): 287–300. doi: 10.1134/S0040601524040025

5. Ontario Power Generation. Small Modular Reactor. Available online: https://www.opg.com/projects-services/projects/nuclear/smr/ (accessed on 10 August 2026).

6. World Nuclear Association. Small Modular Reactor (SMR) Design Database: BWRX-300. Available online: https://world-nuclear.org/information-library/nuclear-power-reactors/small-modular-reactors/small-modular-reactor-smr-design-database?detail=BWRX-300 (accessed on 6 August 2026).

7. Dostal V, Hejzlar P, Driscoll MJ. High-Performance Supercritical Carbon Dioxide Cycle for Next-Generation Nuclear Reactors. Nuclear Technology. 2004; 154(3): 265–282. doi: 10.13182/NT154-265

8. Wu P, Ma Y, Gao C, et al. A Review of Research and Development of Supercritical Carbon Dioxide Brayton Cycle Technology in Nuclear Engineering Applications. Nuclear Engineering and Design. 2020; 368: 110767. doi: 10.1016/j.nucengdes.2020.110767

9. Moisseytsev A, Sienicki JJ. Investigation of Alternative Layouts for the Supercritical Carbon Dioxide Brayton Cycle for a Sodium-Cooled Fast Reactor. Nuclear Engineering and Design. 2009; 239(7): 1362–1371. doi: 10.1016/j.nucengdes.2009.03.017

10. Rogalev N, Rogalev A, Kindra V, et al. Structural and Parametric Optimization of S–CO₂ Nuclear Power Plants. Entropy. 2021; 23(8): 1079. doi: 10.3390/e23081079

11. Ehsan MM, Awais M, Lee S, et al. Potential Prospects of Supercritical CO₂ Power Cycles for Commercialization: Applicability, Research Status, and Advancement. Renewable and Sustainable Energy Reviews. 2023; 172: 113044. doi: 10.1016/j.rser.2022.113044

12. Xiao Y, Zhou Y, Yuan Y, et al. Research Advances in the Application of the Supercritical CO₂ Brayton Cycle to Reactor Systems: A Review. Energies. 2023; 16(21): 7367. doi: 10.3390/en16217367

13. Park JH, Park HS, Kwon JG, et al. Optimization and thermodynamic analysis of supercritical CO₂ Brayton recompression cycle for various small modular reactors. Energy. 2018; 160: 520–535. doi: 10.1016/j.energy.2018.06.155

14. Zhou Y, Zhang Y, Li H, et al. Thermo-Economic and Environmental Analyses of Supercritical Carbon Dioxide Brayton Cycle for High Temperature Gas-Cooled Reactor. Progress in Nuclear Energy. 2024; 177: 105461. doi: 10.1016/j.pnucene.2024.105461

15. Su Z, Wang X, Ming Y, et al. Transient Characteristics of Supercritical Carbon Dioxide Brayton Cycle System with or without Control Strategy under Accident Conditions. Progress in Nuclear Energy. 2025; 185: 105772. doi: 10.1016/j.pnucene.2025.105772

16. Deng Q, Liu A, Li J, et al. A Review on Supercritical CO₂ and CO₂-Based Mixture in Power Cycle. Energy Conversion and Management. 2025; 324: 119295. doi: 10.1016/j.enconman.2024.119295

17. Ming Y, Tian R, Zhao F, et al. Control Strategies and Transient Characteristics of a 5 MWth Small Modular Supercritical CO₂ Brayton-Cycle Reactor System. Applied Thermal Engineering. 2023; 235: 121302. doi: 10.1016/j.applthermaleng.2023.121302

18. Gao C, Zou J, Ma Y, et al. Influence of PCHE Size and Types on Thermodynamic and Economic Performance of Supercritical Carbon Dioxide Brayton Cycle for Small Modular Reactors and Its Optimization. Annals of Nuclear Energy. 2024; 207: 110721. doi: 10.1016/j.anucene.2024.110721

19. Wu Z, Lin D, Zhong D. The Design Features of the HTR-10. Nuclear Engineering and Design. 2002; 218(1–3): 25–32. doi: 10.1016/S0029-5493(02)00182-6

20. She D, Chen F, Xia B, et al. Simulation of the HTR-10 Operation History with the PANGU Code. Frontiers in Energy Research. 2021; 9: 704116. doi: 10.3389/fenrg.2021.704116

21. Ahn Y, Lee JI. Study of Various Brayton Cycle Designs for Small Modular Sodium-Cooled Fast Reactor. Nuclear Engineering and Design. 2014; 276: 128–141. doi: 10.1016/j.nucengdes.2014.05.032

22. Pérez-Pichel GD, Linares JI, Herranz LE, et al. Thermal Analysis of Supercritical CO₂ Power Cycles: Assessment of Their Suitability to the Forthcoming Sodium Fast Reactors. Nuclear Engineering and Design. 2012; 250: 23–34.

23. Turchi CS, Ma Z, Neises TW, et al. Thermodynamic Study of Advanced Supercritical Carbon Dioxide Power Cycles for Concentrating Solar Power Systems. Journal of Solar Energy Engineering. 2013; 135(4): 041007. doi: 10.1115/1.4024030

24. Yu GP, Cheng YF, Zhang N, et al. Multi-Objective Optimization and Evaluation of Supercritical CO₂ Brayton Cycle for Nuclear Power Generation. Nuclear Science and Techniques. 2024; 35(2): 22. doi: 10.1007/s41365-024-01363-y

25. Bell IH, Wronski J, Quoilin S, et al. Pure and Pseudo-Pure Fluid Thermophysical Property Evaluation and the Open-Source Thermophysical Property Library CoolProp. Industrial & Engineering Chemistry Research. 2014; 53(6): 2498–2508. doi: 10.1021/ie4033999

26. Nelder JA, Mead R. A Simplex Method for Function Minimization. The Computer Journal. 1965; 7(4): 308–313. doi: 10.1093/comjnl/7.4.308

27. Zhong D, Xu Y. Progress of the HTR-10 Project. Available online: https://inis.iaea.org/records/8ek9q-mbm82 (accessed on 10 August 2026).

28. Baglietto G, Maccarini S, Traverso A, et al. Techno-Economic Comparison of Supercritical CO₂, Steam, and Organic Rankine Cycles for Waste Heat Recovery Applications. Journal of Engineering for Gas Turbines and Power. 2023; 145(4): 041021. doi: 10.1115/1.4055727

Downloads

Published

2026-11-20

How to Cite

Rogalev, A., Patorkin, D., Murashov, V., Korolev, V., & Malenkov, A. (2026). Thermodynamic analysis of recompression Brayton power cycle for nuclear power plants. Clean Energy Science and Technology, 4(6). https://doi.org/10.18686/cest1073